An online slurry density reading and a reference sample can disagree even when both measurements have been made carefully. They may describe different material, different moments or different conditions in the line.
For UK quarry, mineral-processing and dredging applications, a useful commissioning plan therefore includes the sample comparison from the start. PMA’s Rhosonics SDM ECO overview explains the instrument; the next question is how your team will establish a representative reference.
Start with the measurement point
SDM ECO uses acoustic impedance at the interface between its sensor face and the slurry, with temperature and product calibration used to determine density. The location must keep that sensing interface in material representative of the process.
Review whether the pipe stays full, whether air can accumulate and whether solids settle or segregate near the sensor or sample point. A convenient drain is not automatically a representative sampling location. Include safe isolation and sampling access in the engineering review.
Preserve the comparison before changing calibration
Record where and when the sample was collected, the online value and the operating conditions. A repeatable difference is much easier to investigate when the original evidence is intact.

Match the time and material
Identify the relationship between the sensor and the sampling point. If they are separated, estimate the material travel time under the operating conditions being tested. Compare the reference with the relevant part of the online trend rather than whichever value happens to be displayed after the sample reaches the laboratory.
Record flow or pump state, temperature and any change in feed or dilution. Use a sample-handling procedure that controls settling and loss of material. The point is to establish a defensible comparison, not to force agreement by selecting a convenient moment.
Check the assumptions behind derived results
Density is not automatically a universal solids-concentration result. A conversion depends on the properties of the solids and carrier liquid and the assumptions in the calculation. A change in mineral mixture can change that relationship.
Where density and flow support a mass calculation, align their locations, timestamps and validity. Keep the measured density separate from derived values in the operating record. The SDM ECO installation and commissioning guide sets out the process information to discuss with PMA.
Agree acceptance before commissioning
Write down the reference method, operating range, sampling procedure and acceptance criteria before the trial. Include how the team will investigate a failed comparison and when a calibration adjustment is justified. Repeat the checks over representative operating conditions rather than relying on one sample.
Send PMA a pipe drawing, slurry composition, density and temperature ranges, proposed sensor and sample locations and your reference procedure. This builds on the introductory slurry-density article with a practical plan for commissioning evidence.
Technical references
Rhosonics SDM ECO non-nuclear slurry density meter · Slurry density measurement without a radioactive source





